Our Rally Roof Scoop works in conjunction with the roof vent described below. Made for real rally cars, as a sunroof cannot be operated with this scoop installed (without modifications). Fully formed with great, smooth finish. Fits GC and GD body styles as well as a host of other vehicles from Legacy’s to Toyotas. Wide mouth helps to feed air to your roof vent, but a small air escape in the back of the scoop reduces noise and lift when roof vent is closed. But if you’re just after that snappy rally-car look, install the scoop by itself, without cutting a hole in the roof. Scoop measures approx. 19″ x 17″ and 3.5″ tall. Opening in front is about 13″ wide. Add the HARDWARE KIT as a separate $8 item into your cart for the SCOOP. It contains: qty = 4 M6 stainless steel button head caps crews, fender washers, chrome acorn nuts and washers for a clean, nice install of the scoop, all you do is add some foam body tape (camper tape ~1/8″ thick) under the edges.
The lightweight Aluminum Roof Vent attaches to the underside of your roof skin and allows fresh air to flow into the cockpit thru a 7″ x 3″ opening. The lid fits tight and sits a little proud of the roofline to minimize water entry while raining and to prevent seepage when sitting in the elements. Use with roof scoop (described above) for full effect. Opens forward to push air into cockpit (pressurizing the cabin and reducing dust entry) or also opens BACKWARD to draw air out for a more gentle airflow on transits. Requires medium skill to install and the willingness to cut a hole in your roof. Use body schutz or silicone sealer and rivets for best install.